Volume 6, Issue 2 (Journal OF Welding Science and Technology 2020)                   JWSTI 2020, 6(2): 1-12 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Ebrahimzadeh H, Farhangi H. Fabrication of synchronized hammer peening with pulsed laser welding and its effect on 6061 aluminum alloy weld. JWSTI 2020; 6 (2) :1-12
URL: http://jwsti.iut.ac.ir/article-1-321-en.html
1- School of Metallurgy and Materials Engineering, College of Engineering, University of Tehran, Tehran, Iran
Abstract:   (5669 Views)
The non-continuous laser beam in pulsed lasers allows the mechanical peening between two consecutive beams on a still hot weld bead. At a very short time (20, 150 and 300 ms) after laser pulse application, mechanical peening was performed on the welding bead. To achieve these short times, the light sensor detects the nth laser pulse and the mechanical arm starts moving. Upon reaching the tip of the pin near the workpiece, the n + 1th pulse was irradiated to the workpiece surface, and so the pin impact to the weld bead after traveling a short distance. Desirable mechanical properties were obtained at the highest time (300 ms) and highest pressure (6 bars). In this time and pressure the weld beads were not broken due to bending forces of peening.
Full-Text [PDF 4650 kb]   (1305 Downloads)    

Add your comments about this article : Your username or Email:
CAPTCHA

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2024 CC BY-NC 4.0 | Journal of Welding Science and Technology of Iran

Designed & Developed by : Yektaweb