Volume 6, Issue 2 (Journal OF Welding Science and Technology 2020)                   JWSTI 2020, 6(2): 77-89 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Beheshti Bafqi S A, Mosallaee M. The effect of bonding temperature on the characteristics of TLP bonded joints in AISI 2205/BNi-3/AISI 2205 assembly. JWSTI 2020; 6 (2) :77-89
URL: http://jwsti.iut.ac.ir/article-1-330-en.html
1- Department of Materials Engineering, Yazd university
Abstract:   (4787 Views)
In the present study, the transient liquid phase bonding of AISI 2205 dual phase stainless steel with amorphous BNi-3 interlayer was carried out. Based on the initial experimental and analytical studies, the parameters of temperature and bonding time were determined. In order to investigate the effect of bonding temperature on the microstructural changes of the joint, bonding was performed in the temperature range of 1050-1200℃ for 20 min. The microstructural and phase analyses indicated the completion of isothermal solidification and the formation of a uniform Ni-solid solution in the bonding zone centerline. The interdiffusion between the bonding zone and the adjacent base metal resulted in the formation of boride and nitride intermetallic compounds in the base metal adjacent to the bonding zone, which the area fraction of this intermetallics significantly decreased with increasing bonding temperature from 1050℃ to 1200℃ (reduction of the intermetallic area fraction from 85% to 40%). Evaluation of shear strength of samples showed that despite the completion of isothermal solidification in all samples and shear strength of bonded samples significantly depends of amount and morphology of intermetallic compounds on the transient liquid phase bonding shear strength. By increasing the bonding temperature to 1200℃ and reducing the area fraction of intermetallic compounds up to 40% of the shear strength of the samples increased from 450 MPa of TLP bonded specimen of 1050℃ to about 85% of base metal shear strength.
Full-Text [PDF 2833 kb]   (1241 Downloads)    

Add your comments about this article : Your username or Email:
CAPTCHA

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2024 CC BY-NC 4.0 | Journal of Welding Science and Technology of Iran

Designed & Developed by : Yektaweb